Configuring The Slip (Sl0) Interface On The Console Port - Cisco WS-C2948G-GE-TX Configuration Manual

Configuring the SLIP (sl0) Interface on the Console Port

Console> (enable) show ip route
Fragmentation
-------------
enabled
The primary gateway: 10.1.1.1
Destination
---------------
default
default
default
10.0.0.0
default
Console> (enable)
This example shows how to configure two default gateways on a Catalyst 4500 series, Catalyst 2948G,
Catalyst 2948G-GE-TX, or Catalyst 2980G switch, with one default gateway reachable through the sc0
interface and one reachable through the me1 interface:
Console> (enable) show interface
sl0: flags=50<DOWN,POINTOPOINT,RUNNING>
sc0: flags=63<UP,BROADCAST,RUNNING>
me1: flags=63<UP,BROADCAST,RUNNING>
Console> (enable) set ip route default 172.20.52.33
Route added.
Console> (enable) set ip route default 10.1.1.1
Route added.
Console> (enable) show ip route
Fragmentation
-------------
enabled
The primary gateway: 172.20.52.33
Destination
---------------
default
default
172.20.52.32
10.1.1.0
Console> (enable)
Configuring the SLIP (sl0) Interface on the Console Port
Use the SLIP (sl0) interface for point-to-point SLIP connections between the switch and an IP host.
You must use the console port for the SLIP connection. When the SLIP connection is enabled and SLIP
Caution
is attached on the console port, an EIA/TIA-232 terminal cannot connect through the console port. If you
are connected to the switch CLI through the console port and you enter the slip attach command, you
will lose the console port connection. Use Telnet to access the switch, enter privileged mode, and enter
the slip detach command to restore the console port connection.
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
3-8
Redirect Unreachable
-------- -----------
enabled enabled
Gateway
---------------
10.1.1.1
10.1.1.20
10.1.1.10
10.1.1.100
default
slip 0.0.0.0 dest 0.0.0.0
vlan 5 inet 172.20.52.38 netmask 255.255.255.240 broadcast 172.20.52.47
inet 10.1.1.100 netmask 255.255.255.0 broadcast 10.1.1.255
Redirect Unreachable
-------- -----------
enabled enabled
Gateway
---------------
10.1.1.1
172.20.52.33
4000-2
10.1.1.100
Chapter 3 Configuring the Switch IP Address and Default Gateway
RouteMask Flags Use
---------- ----- --------
0x0 UG 6
0x0 G 0
0x0 G 0
0xff000000 U 75
0xff000000 UH 0
RouteMask Flags Use
---------- ----- --------
0x0 G 0
0x0 UG 12
0xfffffff0 U 180
0xffffff00 U 22
Interface
---------
sc0
sc0
sc0
sc0
sl0
Interface
---------
me1
sc0
sc0
me1
78-15908-01