Cisco WS-C2948G-GE-TX Configuration Manual page 25

Preface
This preface describes who should read the Software Configuration Guide, how it is organized, and its
document conventions.
Audience
This publication is for experienced network administrators who are responsible for configuring and
maintaining Catalyst enterprise LAN switches.
Organization
This publication is organized as follows:
Chapter
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Title
Product Overview
Using the Command-Line
Interface
Configuring the Switch IP
Address and Default Gateway
Configuring Ethernet and Fast
Ethernet Switching
Configuring Gigabit Ethernet
Switching
Configuring Fast EtherChannel
and Gigabit EtherChannel
Configuring Spanning Tree
Configuring Spanning Tree
PortFast, BPDU Guard, BPDU
Filter, UplinkFast, BackboneFast,
and Loop Guard
Description
Presents an overview of the Catalyst enterprise LAN
switches.
Describes how to use the different command-line
interfaces (CLIs).
Describes how to perform a baseline configuration of
the switch.
Describes how to configure Ethernet and Fast
Ethernet switching on the switch.
Describes how to configure Gigabit Ethernet
switching on the switch.
Describes how to configure Fast EtherChannel and
Gigabit EtherChannel port bundles.
Describes how to configure the Spanning Tree
Protocol and explains how spanning tree works.
Describes how to configure the spanning tree
PortFast, UplinkFast, and BackboneFast features.
xxv