Check And Configure Firewall Settings; Dynamic Assignment; Static Assignment; Collect Tools - Cisco Meraki Go GR60 Installation Manual

Table of Contents

1. Attach your GR60 to power and a wired Internet connection. See the "Power the GR60" section for details.

2. The GR60 will turn on and the LED will glow solid orange. If the unit does not require a ﬁrmware upgrade, the LED

will turn either green (no clients associated) or blue (clients associated) within thirty seconds.

* If the unit requires an upgrade, the LED will begin blinking orange until the upgrade is complete, at which point the LED will turn solid green or blue. You should

allow at least a few minutes for the ﬁrmware upgrade to complete, depending on the speed of your internet connection.

Check and Conﬁgure Firewall Settings

If a ﬁrewall is in place, it must allow outgoing connections on particular ports to particular IP addresses. The most current list of outbound ports and IP addresses

for your particular organization can be found here.

Assigning IP Addresses to GR60s

All gateway GR60s (GR60s with Ethernet connections to the LAN) must be assigned routable IP addresses. These IP addresses can be dynamically assigned

via DHCP or statically assigned.

Dynamic Assignment

When using DHCP, the DHCP server should be conﬁgured to assign a static IP address for each MAC address belonging to a Meraki AP. Other

features of the wireless network, such as 802.1X authentication, may rely on the property that the APs have static IP addresses.

Static Assignment

Static IPs are assigned using the local web server on each AP. The following procedure describes how to set the static IP:

1. Using a client machine (e.g., a laptop), connect to the AP wirelessly (by associating to any SSID

broadcast by the AP) or over a wired connection.

2. If using a wired connection, connect the client machine to the GR60 either through a PoE switch or a

PoE Injector. If using a PoE switch, plug an Ethernet cable into the GR60's Ethernet jack, and the other

end into a PoE switch. Then connect the client machine over Ethernet cable to the PoE switch. If using a

PoE Injector, connect the GR60 to the "PoE" port of the Injector, and the client machine to the "LAN"

port.

3. Using a web browser on the client machine, access the AP's built-in web server by browsing

to http://my.meraki.com. Alternatively, browse to http://10.128.128.128.

4. Click on the "Uplink Conﬁguration" tab. Log in. The default login is the serial number (e.g. Qxxx-xxxx-

xxxx), with no password (e.g., Q2DD-551C-ZYW3).

5. Conﬁgure the static IP address, net mask, gateway IP address and DNS servers that this AP will use on

its wired connection.

6. If necessary, reconnect the AP to the LAN.

Static IP via DHCP Reservations

Instead of associating to each Meraki AP individually to conﬁgure static IP addresses, an administrator can assign static IP addresses on the upstream

DHCP server. Through "DHCP reservations," IP addresses are "reserved" for the MAC addresses of the Meraki APs. Please consult the documentation

for the DHCP server to conﬁgure DHCP reservations.