Automatic Maintenance Busy; Set System Date - AT&T MERLIN LEGEND Release 3.1 System Planning Manual

Recording System Operating Conditions

Automatic Maintenance Busy

The factory setting for Automatic Maintenance Busy is Disable, which means
that faulty lines/trunks are not automatically put in a maintenance-busy state.
In Key and Behind Switch modes, Automatic Maintenance Busy usually remains
disabled. If you plan to group lines/trunks into pools in Hybrid/PBX mode,
enable Automatic Maintenance Busy to provide optimal system performance.
For a detailed description of this feature (including considerations and feature
interactions), see the Feature Reference .
Planning Form Instructions
Under the Automatic Maintenance Busy heading in the System Operating
Conditions section of Form 1, page 2, do one of the following:
To keep the factory setting (no maintenance-busy state), check Disable.
To enable Automatic Maintenance Busy, check Enable.

Set System Date

The system date is the month, day, and year, shown on display telephones and
SMDR reports (for information on SMDR, see "System Features" in Chapter 4).
Error reports used by authorized technicians for maintenance also show the
system date and time.
These sections on the planning form remind you to set the system date when
you perform the initial programming for the system.
Planning Form Instructions
Check Yes under the Set System Date heading on Form 1 as a reminder to set
the current date.
2–10
Control Unit Configuration