Updating Planning Information - AT&T MERLIN LEGEND Release 3.1 System Planning Manual

Numbering the System
If you want to renumber only a few of the extensions and there are
enough numbers available for 2- and 3-digit numbering plans:
a. Check the 2-Digit, the 3-Digit, or the Set Up Space box to indicate
b. Write the new extension number(s) in the Renumber to columns on
Proceed to the next section, "Updating Planning Information."

Updating Planning Information

On the floor plan, add the extension number beneath the symbol for each
telephone and adjunct. If you are using a system programming console, go to
Form 1, System Planning, in the System Operating Conditions section and add
the new extension number of the console in the space next to Ext. No.
NOTE:
The remaining columns on Form 2a (Eqpt., Label, Old Ext. No., and Wire No.)
are completed by the technician during installation.
To complete the forms for lines/trunks, proceed to Chapter 3, "Lines/Trunks."
the numbering plan you're using. Be sure to check Selected
Extension Numbers under the Renumber System heading on Form
2a , page 1 .
Form 2a and Form 2b.
Control Unit Configuration
2–31