Line Compensation Settings - Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Selecting Line/Trunk Options
Table 3-3.
Setting
1 (factory setting)
2
3
4
5
1 Based on 22-gauge cable.
8. If the system includes both 800 NI-BRI and 100D modules, clock
synchronization planning should be completed at the same time. There is
only one primary/secondary/tertiary clock for both 800 NI-BRI modules and
100D modules, with the same system programming screens used for both
types.
Plan your clock source administration to minimize the need for clock
switching, which is known to cause noise on active calls.
Under Priority in the Clock Synchronization section, do either of the
following:

Line Compensation Settings

NOTE:
The following information is for planning clock synchronization in
systems that are not part of a private network. For planning clock
synchronization in a private network configuration, see the Network
Reference .
If installing only one 100D module:
— To keep the factory setting, check Primary (that is, this
module provides synchronization for the system).
— If the synchronization source is other than through the 100D
module, check None.
If installing more than one 100D module, decide which module, if
any, provides the primary synchronization:
— If Module 1 provides clock synchronization, check Primary in
the first box (the factory setting).
— If Module 2 (or Module 3) provides clock synchronization,
check Primary in the box that describes that 100D module.
dB Loss Cable Feet
-0.6 0 133
-1.2 133 266
-1.8 266 399
-2.4 399 533
-3.0 533 655
Issue 1
April 1999
3-27
1