Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 432

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
Glossary
Baud Rate
B-Channel
Basic Rate
Interface
Bearer-Channel
Behind Switch
Mode
Binary Code
Bipolar 8 Zero
Substitution
Bipolar Signal
Bipolar Violation
BIS
Bit
Bit Rate
Blocking
BMI
Board
Board Assignment
Board
Renumbering
Strictly speaking, a measurement of transmission speed
equal to the number of signal level changes per second. In
practice, often used synonymously with bit rate and bps .
Bearer-Channel . 64- or 56-kbps channel that carries a
variety of digital information streams, such as voice at
64 kbps, data at up to 64 kbps, wideband voice encoded at
64 kbps, and voice at less than 64 kbps, alone or
combined.
See BRI .
See B-Channel .
One of three modes of system operation in which the
control unit is connected to (behind) another telephone
switching system, such as Centrex or DEFINITY, which
provides features and services to telephone users. See
also Hybrid/PBX Mode
Electrical representation of quantities or symbols
expressed in the base-2 number system, which includes
zeros and ones.
B8ZS
See .
Digital signal in which pulses (ones) alternate between
positive and negative. See also
Violation .
Condition occurring when two positive or two negative
pulses are received in succession. See also
B8ZS .
Built-In Speakerphone . Part of the model name of some
analog multiline telephones.
Binary Digit . One unit of information in binary notation; it
can have one of two values—zero or one.
Speed at which bits are transmitted, usually expressed in
bps . Also called "data rate."
Condition in which end-to-end connections cannot be made
on calls because of a full load on all possible services and
facilities. See also Glare.
Broadcast Music Incorporated .
Module—for example, 100D or 408 MLX GS/LS—that
allows you to connect lines/trunks and extensions to the
communications system.
System Programming and Maintenance (SPM) procedure
for assigning line/trunk and extension modules to slots on
the control unit.
System programming procedure for renumbering boards
that have already been assigned to specific slots on the
control unit.
and Key Mode .
AMI , B8ZS , and
Issue 1
April 1999
GL-4
Bipolar
AMI and