Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 112

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
2 Control Unit Configuration
Numbering the System
Planning Form Instructions
On Form 2a, mark the extension assignments for the remaining analog multiline
telephones:
1. In the Jack Type column, make sure A is checked next to the logical ID for
each analog extension jack.
2. In the Person, Location, or Function column, identify each analog multiline
telephone by the user's name, location, or function.
Jacks for the CTI Link Application
Use these instructions only if the system has 008 MLX, 408 GS/LS-MLX, or 408
GS/LS-ID-MLX modules; or, in Release 7.0 and later systems, an 016 MLX
module; and if users will be using CTI applications and a CTI Server
(PassageWay Telephony Services for NetWare or CentreVu Computer-Telephony
Services for Windows NT). Otherwise, skip to the next section,
Equipment and
The CTI link allows the computer users to interact directly with the
communications system and obtain access to features through the use of a
computer. Once installation is completed, the CTI port does not need feature
programming, but the port and extension information must be recorded so it can
be used when programming the network features.
If an MLX or analog multiline telephone extension is going to have a CTI-capable
program installed on the extension's worktop PC, then you need to identify both
the CTI link extension (the MLX port extension that connects to the CTI Server),
and the MLX or analog multiline telephone extensions that will have the CTI-
capable program installed. Single-line telephones cannot make use of CTI.
If the CTI link is on the first MLX module in the system, then perform
administration for the CTI link using SPM. If the CTI link is not on the first MLX
module, then you can use the system programming console to do the
programming.
CTI can be used only on Release 5.0 and later communications systems in
Hybrid/PBX mode.
To get the Incoming Caller ID (ICLID) information, LS-ID delay must be set to On
(factory setting is Off).
To use a CTI application for Call Control features (Hold, Hold retrieve, Consult,
Transfer, or Conference), the call must be on an SA button.
A monitored extension is one that is connected to a CTI application that can
handle the call; the application should be used to handle the calls. An
unmonitored extension is not connected to a CTI application.
Applications."
2
''Jacks for Tip/Ring
Issue 1
April 1999
2-30
2