Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 160

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Selecting Line/Trunk Options
identification. If the telephone company has directed you to change this
information, obtain the correct entry from them. But note that the dial
pattern must come first. Entry 1 represents current national standards for
specifying long-distance carriers (asterisks represent the common carrier
code wildcard so that anything will match). Entry 0 represents the coming
national standards. The remaining entries are reserved for future use.
6. In the Special Services Table:
a.
b.
c.
d.
7. For all call-by-call B-channel groups, to route all outgoing calls over a
call-by-call B-channel group, you must program the Call-by-Call Service
Table to direct the system to properly route calls. Record table entries
(maximum: 10) on Form 3b (page 8):
a.
b.
NOTE:
The Network Selection Table and the Special Services Table contain
factory settings that reflect U.S. standards for public telephone
network access. These factory settings can be modified to conform
to other standards. You should not change them, however, unless
the telephone company explicitly instructs you to do so.
In the Pattern to Match cell, write the exact dial pattern to match.
(No wildcards are permitted.)
In the Operator cell, indicate Local Operator (OP), Presubscribed
Operator (P), or No Operator service (none) associated with the
pattern.
In the Type of No. cell, indicate whether the pattern is for calling
National (N) or International (I).
To delete digits, write the number of digits to delete (0 4). (The
system deletes from the first digit forward.)
In the Pattern to Match cell, write the dial pattern to match (up to 8
digits). No wildcards are permitted.
In the Call Type cell, indicate the type or types of calls that will be
associated with the pattern by doing one of the following:
If all outgoing calls will be voice calls (for example, Megacom
WATS), write
If all outgoing calls will be data only (for example,
ACCUNET), write
If outgoing calls may be either voice or data (for example,
SDN), write
NOTE:
If you indicate , make sure the service can support both voice
and data calls.
.
.
.
Issue 1
April 1999
3-38