Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 143

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
3 Lines/Trunks
Selecting Line/Trunk Options
b.
7. For Class-of-Restriction without Barrier Codes on Form 3a (page 3),
complete the DID and Private Network Tie Trunks and Non-Tie Trunks
sections as follows:
a.
b.
3. Complete the Line/Trunk Type and Description column.
Include the different calling areas of WATS trunks and
different destinations of FX trunks. If a private network trunk,
write
For each line/trunk, check the Dedicated column (to indicate that it is
always used for remote access) or the Shared column (to indicate
that it is used for remote access when the system is in Night Service
operation). Do not check either column for private network trunks.
Under the Network Calls heading, check one of the boxes using the
following information:
— If the switch is not part of a private network, check None.
— If the switch is part of a private network, and tandem calls will
pass through this system, check Tandem.
— If the switch is part of a private network, and network calls will
be allowed to access PSTN trunks, check ARS.
NOTE:
If Tandem or ARS is selected under Network Calls, the
Restriction should be set to Unrestricted. For additional
information on private networks, see the Network Reference .
For Restriction, check one of the following three boxes:
Unrestricted, Outward Restrict (to keep the factory setting), or Toll
Restrict.
.
Issue 1
April 1999
3-21