Lucent Technologies MERLIN LEGEND Release 7.0 System Planning Manual page 234

MERLIN LEGEND Communications System Release 7.0
System Planning 555-670-112
4 Features
Group-Assigned Features
Planning Form Instructions
For each calling group:
1. On Form 7d (page 2), copy the Group No., ID, and extension number from
the front of the form.
2. Select the Hunt Type by doing one of the following:
Under the Primary Delay Announcement heading, do one of the following:
3.
4. Under the Secondary Delay Announcement heading, do one of the
following:
To keep the factory-set hunting pattern, check the Circular box.
NOTE:
If you choose a Linear hunt, be sure you have listed the
extension numbers and names in the Extensions section on
Form 7d (page 1), in the order that you want the group
searched. If you have not done this, go back and correct the
front of the form so that the extensions are in the right order.
To change the factory-set hunting pattern to Linear, check the Linear
box.
To change the factory-set hunting pattern to Most-Idle, check the
Most-Idle box.
If there are no announcement devices, check the No box and
proceed to Step 4.
To designate one or more announcement devices, check the second
box and write the extension numbers for the devices in the space
provided (see Form 2a or 2b).
If there is no secondary announcement device, check the No box
and proceed to Step 5.
To designate a secondary announcement device, check the second
box and write the extension number for the device in the space
provided (see Form 2a or 2b). Also do the following:
— Write in the desired Delay Interval between the primary
announcement and the secondary announcement in
seconds. The Delay Interval is also the time between repeats
of the Secondary Announcement, if the Repeat
Announcement option is set.
Issue 1
April 1999
4-36
4