Setting Business Hours - Altigen AltiWare OE/ACC Version 5.0 Administration Manual

Setting Business Hours

Note:
After setting the IP Trunk Access code here, you should set the
Trunk Access Codes of any 30-port VoIP boards to "None" on the
General tab of the Trunk Configuration window (see "Setting
General Trunk Attributes" on page 7-3). This will prevent users
from directly accessing the 30-port boards—which use the G.711
codec only—for calls to AltiServ servers or other IP gateways that
may require the G.723 codec. If you still want users to have access
to this trunk for outgoing calls, you can set it up through Outcall
Routing (see Chapter 8, Out Call Routing Configuration).
Route Access
The Route Access option can be assigned to one or more digits, to route the
call per the out call routing table. Out call routing, which is sometimes
called ARS (Automatic Route Selection) or LCR (Least Cost Routing
without carrier rate table), is described in Chapter 8, Out Call Routing
Configuration.
Out call routing is designed to help 10-digit dialing, zoomerang dialing,
digit manipulation, and tie trunk hop-off dialing.
Note:
When making or editing these or other number plan assignments,
refer to the considerations on setting and editing discussed in
"Setting a System Number Plan" on page 5-4.
Setting Business Hours
The Business Hours tab contains group boxes for setting the business hours
and days of the week for which the business or organization is in operation.
The business hours schedules are used to set other AltiWare settings such
as trunk usage or routing DNIS calls to different extensions depending on
the time and day.
Note:
Because the business hours are used throughout the system, you or
the appropriate administrator must make sure the system time
has been set correctly. The system time can be changed using the
Date/Time utility in the Windows or NT Control Panel.
5-10 AltiWare OE System Installation & Administration Manual