Cme Line - Xerox 6100BD - Phaser Color Laser Printer Software Manual

Specifying print format parameters
CME INK
parameter: points
to note
Syntax
Options
Table 4-18. CME LINE parameter options and definitions
Option
n
m
–
Default

CME LINE

parameter: point
to note
4-16
• If 0 is specified (or defaulted) for the INK parameter, the ink
for the variable data and the CME text reverts to the ink that
was specified in the IDFAULT parameter of the OUTPUT
command.
• An inkindex value greater than the ILIST size causes an "out
of range" message to be displayed. The operator has the
option to continue printing the job using black ink or to abort
the job.
CME LINE
Specifies the line range within which the CME is located on the
page.
ac: CME LINE = {n | (n, m) | (n, –)}
Definition
The initial line number of the copy modification rectangle
The number of lines to repeat the information. If not specified, the information
applies only to the starting line.
A dash character indicates that information is to apply to all lines on a page
beginning with the line indicated by n.
No default.
The line numbers specified in the LINE parameter must always
be in ascending order. In other words, you cannot specify one
line number, then list another one of lower value in the same
command. For example, the following command is incorrect and
will not be compiled:
CME1: CME LINE =(2,3), POS=15,
CONSTANT=(6),'HELLO', FONTINDEX=3,
LINE=1, POS=15;
As you can see, the first line parameter specifies starting at line
2, while the second LINE parameter specifies line 1, which
contradicts the ascending order.
Using LCDS Print Description Language