Output Invert - Xerox 6100BD - Phaser Color Laser Printer Software Manual

Default
OUTPUT IMAGE
parameter: points
to note
OUTPUT IMAGE
parameter
example
Syntax
Options
Using LCDS Print Description Language
Top left corner of the portrait or landscape oriented page, scaled
at 1/1
• To put an image on a page, use a form with the image, or use
the IMAGE DJDE.
• If the UN option is used to define positioning, the UNITS
parameter must precede this command.
• The IMAGE parameter must follow the GRAPHICS=BATCH
parameter, as these two parameters are order dependent.
• If two IMAGE parameters are listed consecutively in a JDL,
the system processes only the second one.
• Existing .IMG files are printed in the system default black ink
unless ink references are specified in the INK parameter.
• If ink references are used:
– If one inkref in the list is omitted, commas must be used
as place holders to maintain the relative positioning of the
remaining ink references.
– If more than two ink references are specified, the
additional ink references are ignored.
Following is an example of the OUTPUT GRAPHIC parameter.
OUTPUT GRAPHIC=BATCH, IMAGE=(1 IN,2 CM);

OUTPUT INVERT

Specifies that the content of a page will be inverted 180 degrees
when it is printed on the physical page, head to head or head to
toe. Inversion is also used for page orientation for finishing
functions.
OUTPUT INVERT = {FRONT | BACK | BOTH | NONE}
Table 4-60. OUTPUT INVERT parameter options and
Option
FRONT
BACK
Specifying print format parameters
definitions
Definition
Specifies page inversion on front sides.
Specifies page inversion on back sides.
4-61