Trans Djde; Trans Djde: Points To Note - Xerox 6100BD - Phaser Color Laser Printer Software Manual

Using Dynamic Job Descriptor Entries (DJDEs)

TRANS DJDE

Type
Syntax
Options
5-72
For example, if the initial TOF and BOF values are 2 for every
job, a page transition occurs every time a data record is
processed because the TOF and BOF have the same value.
If a TOF DJDE specifying a value of 1 is processed and the
page transition has already occurred, the TOF DJDE value is
too late and does not take effect until the next page transition.
• The value option is defined the same as in the VFU
command, described in the "Specifying print format
parameters" chapter.
• If the value specified in the TOF DJDE is greater than or
equal to the BOF (Bottom Of Form) value, the TOF value is
set to 1.
Specifies whether or not transparencies are used in the print job.
Page oriented
TRANS = {YES | NO}
Table 5-62. TRANS DJDE options and definitions
Option Definition
YES Specifies that transparencies are used in the print job.
NO Specifies that transparencies are not used in the print job.

TRANS DJDE: points to note

• The TRANS DJDE is used to force parameters when
transparencies are used and to minimize paper jams. If
TRANS=YES is specified, the following parameters are
forced:
– DUPLEX=NO
– ACCT=TRAY
– BFORM is ignored.
– For the RPAGE command, the NUBACK parameter is
forced to NUFRONT.
Using LCDS Print Description Language