Output Logo - Xerox 6100BD - Phaser Color Laser Printer Software Manual

Syntax
Options
Table 4-62. OUTPUT LOGO parameter options and definitions
Option
name
vpos
hpos
units
INKS
inkindex
Default
Using LCDS Print Description Language

OUTPUT LOGO

Allows you to specify a logo for imaging on all pages of a report,
unless it is canceled by a CANCEL DJDE. Up to 128 logos can
be specified on a page.
OUTPUT LOGO = (name, vpos units, hpos units [, INKS,
inkindex [, inkindex
1
Definition
Name of the logo file
vertical position
A value constant that specifies as an offset the vertical position of the top edge
of the logo relative to the 0,0 position on the current physical page (the position
that would be specified by a PDE BEGIN parameter value of 0,0).
horizontal position
A value constant that specifies as an offset the horizontal position of the left
edge of the logo relative to the 0,0 position on the current physical page.
The unit of measurement for the vertical and horizontal positions offset value.
Options are:
• DOTS
• XDOTS (600 dpi dots)
• CM (centimeters)
• IN (inches)
The default unit is IN.
Indicates that the ink that follows will override the inks that are defined in the
logo.
Overrides the corresponding inks that are specified in the ink list of the logo.
NOTE: For this option to be valid, the logo that is referenced must be in color
format.
No default
Specifying print format parameters
])])
2
4-63