Line Margin; Line Overprint - Xerox 6100BD - Phaser Color Laser Printer Software Manual

Specifying print format parameters
Default
LINE LPI
parameter: points
to note
Syntax
Options
Table 4-34. LINE MARGIN parameter options and definitions
Option
value
valuetype
Default

LINE MARGIN

parameter: point
to note
Syntax
4-32
No default
• If the LARGE[ST] is specified for the LINE BASELINE
parameter, the LPI parameter is ignored.
• The line spacing value is not based on the maximum LPI font
of the line. Instead, it is based on the value that is specified in
the command:
LINE LPI = LINESPACING
LINE MARGIN
Specifies the left printing margin within each logical page.
LINE MARGIN = {value | (value, valuetype)}
Definition
Specifies the distance from the left edge of the logical page (as indicated by the
current BEGIN value in effect) to the left margin. Has the format nnn.mm (a
positive decimal number of up to three digits, with up to 2 digits to the right of
the decimal point).
Unit of measure for the margin value. Available unit options include:
• IN (inches)
• CM (centimeters)
• POS (character positions).
NOTE: When you run a CODE=NONE job with DUPLEX=YES and
SHIFT=YES, you must specify MARGIN in inches.
(1, POS)
A value must be specified as an integer (nnn) if its valuetype is
character positions (POS).

LINE OVERPRINT

Specifies how overprint lines are handled. (Overprint lines are
print lines whose carriage control specifies printing with no line
spacing after the last printed line.)
LINE OVERPRINT = (overopt, disp)
Using LCDS Print Description Language