Xerox 6100BD - Phaser Color Laser Printer Software Manual page 394

Using Dynamic Job Descriptor Entries (DJDEs)
Options
Option
name
vpos
hpos
units
H
n/d
INKS
inkref
5-40
Table 5-29. GRAPHIC DJDE options and definitions
Definition
Identifies the graphic.
If document interleaved, it becomes the file name with which the .IMG file is
written.
If page interleaved, it is used to associate the graphic with other DJDE
references.
vertical position.
Specifies the amount of vertical spacing of the top edge of the graphic from 0,0
on the physical page.
horizontal position.
Specifies the horizontal spacing of the left edge of the graphic from 0,0 on the
current physical page.
Unit of measure for the vertical and horizontal positions of the graphic. The
following may be used:
• UN (unit defined by the user)
• CM (centimeters)
• IN (inches)
• DOTS
• XDOTS (DOTS for 600 spi processing)
If UN is specified, the user defined positioning unit must be previously defined
by the OUTPUT UNITS command in the current JDE or JDL.
The default positioning unit is IN.
HOLD
Specifies that the same graphic is to be held and imaged without further
callouts at the same position and with the same scale factor at all subsequent
pages until changed by a DJDE CANCEL or ALTER DJDE.
numerator/denominator
Specifies the reference scale factor. Each option, n and d, must be an integer
in the range of 1 to 8, thereby allowing a reference scale factor in the range of
1/8 to 8. The reference scale factor is multiplied by the internal scale factor of
the image.
Specifies that the ink references that follow will override the inks that were
defined in the image file.
ink reference
Specifies the inks that override the corresponding inks specified in the ink list of
the image file.
Using LCDS Print Description Language