Initial Computer Configuration And Deployment; Installing A Remote System; Copying A Setup Configuration To Another Computer - HP Z238 Maintenance And Service Manual

Initial computer configuration and deployment

The computer includes a preinstalled system software image. After a brief software unbundling process, the
computer is ready to use.
If you prefer to replace the preinstalled software image with a customized set of system and application
software, you can deploy a customized software image by:
Installing additional software applications after unbundling the preinstalled software image
●
● Using a disk-cloning process to copy the contents from one hard drive to another
The HDD-based HP Recovery Manager ROM-based setup, and ACPI hardware provide further assistance with
recovery of system software, configuration management and troubleshooting, and power management.
Support for specific features described in this guide can vary by model and software version.
The best deployment method depends on the information technology environment and processes.

Installing a remote system

Remote system installation enables starting and setting up the computer using software and configuration
information on a network server. This feature is usually used for system setup and configuration and can be
used to:
● Deploy a software image on new PCs
● Format a hard drive
● Install application software or drivers
Update the operating system, application software, or drivers
●
To initiate a remote system installation, press
right corner of the HP logo screen. Follow the on-screen instructions to continue the installation process. The
default boot order is a BIOS configuration setting that can be changed to always attempt a network boot.

Copying a setup configuration to another computer

This section provides information about replicating the computer setup.
CAUTION:
computers are not the same model.
To copy a setup configuration:
1. Select a setup configuration to copy, and then restart the computer.
2. As soon as you start or restart the computer, press and hold
Utility. If necessary, press
NOTE:
and hold
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
3. Select Main > Replicated Setup > Backup current settings to USB device. Follow the instructions on the
screen to create the configuration file cpqsetup.txt and write it to a USB storage device.
4. Turn off the computer you are configuring and insert the removable USB media device containing the
configuration file.
24 Chapter 2 System management
Setup configuration is model-specific. File system corruption can result if source and target
enter
If you do not press F10
F10 again to access the utility.
f12 when f12=Network Service Boot appears in the lower-
to bypass the title screen.
at the appropriate time, you must restart the computer, and then press
F10 until you enter Computer Setup (F10)