Download  Print this page

Replicating The Setup; Copying A Setup Configuration To A Single Computer - HP Z200 Maintenance And Service Manual

Small form factor workstation.
Hide thumbs

Advertisement

Replicating the setup

This section provides information about replicating the computer setup.

Copying a setup configuration to a single computer

CAUTION:
target computers are not the same model.
To copy a setup configuration:
1.
Select a setup configuration to copy, and then restart the computer.
2.
As soon as the computer powers on, press and hold
Utility. If necessary, press
NOTE:
press and hold
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
3.
Select File>Replicated Setup>Save to Removable Media. Follow the instructions on the
screen to create the configuration diskette or USB media device.
4.
Power off the computer you are configuring and insert the configuration diskette into the diskette
drive or USB media device.
5.
Power on the computer you are configuring.
6.
Press and hold the
Enter
7.
Select File>Replicated Setup>Restore from Removable Media, and then follow the
instructions on the screen.
8.
Restart the computer when the configuration is complete.
40
Chapter 4 System management
A setup configuration is model-specific. File system corruption can result if source and
Enter
If you do not press
F10
F10
again to access the utility.
F10
key until you enter the Computer Setup (F10) Utility. If necessary, press
to bypass the title screen.
F10
to bypass the title screen.
at the appropriate time, you must restart the computer, and then
until you enter the Computer Setup (F10)
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Z200

This manual is also suitable for:

Z200

Comments to this Manuals

Symbols: 0
Latest comments: