Figure 51 Mbf Pick Up Shaft; Rrp 2.5 Mbf Retard Holder Assembly - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RRP 2.5 MBF Retard Holder Assembly

(See PL 4.2 Paper

Figure 51 MBF Pick Up Shaft

Removal
Warning: Switch off the power and disconnect the Power Cord.
1. Remove the MBF Assembly (RRP 2.1 Multi-sheet Bypass Feeder (MBF)
Assembly).
2. Remove the MBF Gear Cover (RRP 1.8 MBF Gear Cover).
3. Remove the Pick-up Spring from the MBF Pick-up Gear.
4. Release the two locking tabs on the MBF Pick-up Gear and remove the gear.
5. Move the MBF Pick-up Shaft to the right and remove the shaft from the MBF.
6. Remove the screw that secures the support bracket to the MBF. Remove the
bracket.
7. Insert a screwdriver between the left side of the MBF and the MBF Tray Assembly
near the tray pivot point. Carefully spread the two assemblies until the tray
disengages from the MBF.
8. Release the two locking tabs on the back of the retard holder and rotate the retard
holder forward.
9. Continue to rotate the holder forward until it can be lifted out of the MBF base.
264
Handler)
Phaser 5400 Laser Printer Service Guide