Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual page 240

Table 114 Damaged Print Troubleshooting Procedure (cont'd.)
Step Actions and Questions
5 PAPER PATH INSPECTION
Inspect the paper path between the feed tray and the
exit tray for contamination or obstructions.
Is the paper path free of obstructions and
contamination?
ROLLER INSPECTION
6
Inspect all of the roller along the paper path, between
the feed tray and the exit tray, for contamination, wear
or damage.
Are the paper path roller free of contamination,
wear or damage?
7 PRINT CARTRIDGE REPLACEMENT
1. Install a new Print Cartridge.
2. Run a Test Print.
Is the print still damaged?
SUSPECT COMPONENTS
8
The following printer components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this Repair Analysis Procedure, replace each
component or troubleshoot each area listed below, one
at a time, until you isolate and solve the problem.
Fuser Assembly [RRP 5.1,
I
Paper Transport Assembly [RRP 4.1,
I
BTR Assembly [RRP 7.6,
I
MBF Feed Roller Assembly [RRP 2.2,
I
Retard Holder Assembly [RRP 2-5]
I
Rear Chute Assembly [RRP 3.1,
I
Turn Roller Assembly [RRP 2-4]
I
Feed Roller [RRP 2.10,
I
Tray Assembly [PL 2.1 / PL 2.2]
I
Phaser 5400 Laser Printer Service Guide
page 288]
page 283]
pagepage 304]
page
page 273]
page 271]
Yes
Go to
Step 6.
Go to
Step 7.
Go to
Step 8.
261]
No
Remove
obstructions
or
contamination
from the
paper path.
Replace the
damaged or
contaminated
roller.
Problem
solved.
211