Table 26 Error Code C5: Standard Bin Full Troubleshooting Procedure; Rap - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RAP 6 Error Code C5:
Error code indicates the Standard Bin is full.
Table 26 Error Code C5: Standard Bin Full
Troubleshooting Procedure
Step Actions and Questions
1 STACK FULL SENSOR TEST
1. Enter Diagnostics mode.
2. From the Main Menu, select Component Test / Sensor
Input / press [4] to start, [0] to stop.
3. Actuate and deactuate the Stack Full Sensor Actuator.
Does the LCD counter increment each time you
press and release the actuator?
2 STACK FULL SENSOR ACTUATOR INSPECTION
Visually inspect the Stack Full Sensor Actuator.
Does the actuator move freely and appear to be
in good condition (not broken or damaged)?
3 "YES" FROM STEP 2 ABOVE
1. Switch printer power OFF.
2. Remove the Left Side Cover [RRP 1.1,
the Print Engine Controller Board Cover [RRP 8.5,
page 310].
3. Disconnect P/J19 from the Print Engine Controller
Board.
4. Switch printer power ON.
5. Measure the voltage between P/J19-11 and frame
ground, then between P/J19-13 and frame ground.
Do both voltages measure +3.3 VDC?
"NO" FROM STEP 3 ABOVE
4
Measure the voltage between P/J16-4 and frame
ground.
Does the voltage measure +3.3 VDC?
52
Remove Output
From Std. Bin
Yes
It appears
the HCS
Stack Full
Sensor is
working
correctly. If a
problem
persists,
replace the
Print Engine
Controller
Board
[RRP 8.5,
page
Go to
Step 3.
Go to
Step 5.
page 250 and
Replace the
Print Engine
Controller
Board
[RRP 8.5,
page
Phaser 5400 Laser Printer Service Guide
No
Go to
Step 2.
310].
Replace the
Stack Full
Sensor
Actuator
[RRP 5.4,
page 294].
Go to
Step 4.
Replace the
LVPS
[RRP 8.6,
page 312].
310].