Table 25 Add Paper To 500-Sheet Feeder Troubleshooting Procedure; Rap 5 Load Tray 2 / Load Tray 3 - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RAP 5 Load Tray 2 / Load Tray 3

Tray 2 or Tray 3 is out of paper.
Table 25 Add Paper To 500-Sheet Feeder
Troubleshooting Procedure
Step Actions and Questions
1 PAPER LEVEL
Check the paper level in the indicated Tray Assembly.
Is there paper in the indicated tray?
2 TRAY 2/3 BOTTOM PLATE
1. Remove the tray from the 500-Sheet Feeder
Assembly.
2. Remove the Tray Cover and all paper from the tray.
3. Insert the Tray into the 500-Sheet Feeder Assembly
and inspect the Bottom Plate.
Is the bottom plate raised?
NO PAPER SENSOR ACTUATOR
3
1. Remove the Paper Tray.
2. Manually actuate the No Paper Sensor Actuator.
Does the No Paper Sensor Actuator move
smoothly?
4 NO PAPER SENSOR
1. Enter Diagnostics mode.
2. From the Main Menu, select Component Test / Sensor
Input / press [4] to start, [0] to stop.
3. Press and release the No Paper Sensor Actuator.
Does the LCD counter increment when you press
and release the actuator?
5 "NO" FROM STEP 4 ABOVE
1. Switch printer power OFF.
2. Remove the 500-Sheet Feeder Left Cover [RRP 11.3,
page 330].
3. Disconnect P/J 133, and switch printer ON.
4. Measure the voltage between P133-4 and frame
ground, then between P133-6 and frame ground.
Do both voltages measure +3.2 VDC?
50
Yes
Go to
Step 2.
Go to
Step 3.
Go to
Step 4.
Replace the
Print Engine
Controller
Board
[RRP 8.5,
page
Go to
Step 6.
Phaser 5400 Laser Printer Service Guide
No
Load paper
into the Tray.
Replace the
Tray [PL 2.1,
page 386 /
PL 2.2,
page 388].
Replace the
No Paper
Sensor
Actuator
[RRP 11.20,
page 350].
Go to
Step 5.
310].
Check for
continuity
between
P/J133 &
P/J13A, then
between
P/J13A &
P/J134.
Repair or
replace as
necessary. If
the harness
checks OK,
replace the
No Paper
Sensor
[RRP 11.19,
page 348].