Table of Contents
Advertisement
RAP 62 500-Sheet Feeder Feed Solenoid
The 500-Sheet Feeder is not feeding paper or not feeding paper at the correct time.
Table 92
500-Sheet Feeder Feed Solenoid
Troubleshooting Procedure
Step Actions and Questions
PROCEDURE
1
1. Enter Diagnostics mode.
2. From the Main Menu, select Component Test / Tray 2
Feed Sol (or Tray 3 Feed Sol) / press [4] to start.
Can you hear the solenoid energize?
"NO" FROM STEP 2 ABOVE
2
1. Switch printer power OFF.
2. Remove the 500-Sheet Feeder Left Cover [RRP 11.3,
page
330].
3. Disconnect P/J133 on the Feeder Board.
4. Measure the resistance between pins 10 and 11 on
the disconnected plug.
Does the resistance measure approximately
90 ohms?
3
"NO" FROM STEP 2 ABOVE
1. Disconnect P/J135 from the Feed Head Assembly.
2. Measure the resistance between P135-1 and P135-2.
Does the resistance measure approximately
90 ohms?
4
"YES" FROM STEP 2 ABOVE
1. Switch printer power ON.
2. Measure the voltage between P/J133-10 on the
Feeder Board and frame ground.
Does the voltage measure +24 VDC?
5
"NO" FROM STEP 4 ABOVE
Measure the voltage between P/J132-3 and frame
ground.
Does the voltage measure +24 VDC.
"NO" FROM STEP 5 ABOVE
6
1. Switch printer power OFF.
2. Remove the print Left Side Cover [RRP 1.1,
page
250] and the Print Engine Controller Board
Cover [RRP 8.5,
3. Switch printer power ON.
4. Measure the voltage between P/J13-3 and frame
ground.
Does the voltage measure +24 VDC?
Phaser 5400 Laser Printer Service Guide
page
310].
Yes
No
Go to
Go to
Step 10.
Step 2.
Go to
Go to
Step 4.
Step 3.
Repair or
Replace the
replace the
Tray 2/3
Feed Head
Feed
Harness
Solenoid
[PL 11.3,
[RRP11.10,
page
416].
page
Go to
Go to
Step 7.
Step 5.
Replace the
Go to
Feeder
Step 6.
Board
[RRP 11-7,
page
334].
Check the
Replace the
continuity of
Print Engine
the Feeder
Controller
Harnesses
Board
[P/J132 to
[RRP 8.5,
page
P/J131 and
P/J131 to
P/J13].
Repair or
replace as
necessary.
337].
310].
161
Advertisement
Chapters
Table of Contents
Troubleshooting
