Table 28 Add Paper To 2000-Sheet Feeder Troubleshooting Procedure; Rap 8 Load Tray 2 / Load Tray 3 - Xerox 5400N - Phaser B/W Laser Printer Service Quick Reference Manual

RAP 8 Load Tray 2 / Load Tray 3

The last sheet of paper was fed.
Table 28 Add Paper to 2000-Sheet Feeder
Troubleshooting Procedure
Step Actions and Questions
PROCEDURE
1
Open the 2000-Sheet Feeder paper tray.
Is there paper in the tray?
2 NO PAPER SENSOR ACTUATOR
1. Open the 2000-Sheet Feeder Tray Assembly.
2. Inspect the No Paper Sensor Actuator.
Is the actuator in good condition and does it
move freely?
3 NO PAPER SENSOR TEST
1. Enter Diagnostics mode.
2. From the Main Menu, select Component Test / Sensor
Input / press [4] to start, [0] to stop.
3. Manually push the No Paper Sensor Actuator up and
release.
Does the LCD counter increment each time you
press and release the No Paper Sensor
Actuator?
4 "NO" FROM STEP 3 ABOVE
1. Switch printer power OFF.
2. Open the 2000-Sheet Feeder Tray Assembly.
3. Remove the Lower Rear Cover.
4. Disconnect P/J602 from the 2000-Sheet Feeder
Board.
5. Switch printer power ON.
6. Measure the voltage between P/J602-3 and frame
ground.
Does the voltage measure +3.2 VDC?
5 "NO" FROM STEP 4 ABOVE
Measure the voltage between P601-1 and frame
ground.
Does the voltage measure +3.2 VDC?
"NO" FROM STEP 5 ABOVE
6
1. Switch printer power OFF.
2. Check for continuity between P/J13-1 and P601-1.
Is there continuity between the pins?
58
Yes
Go to
Step 2.
Go to
Step 3.
Replace the
Print Engine
Controller
Board
[RRP 8.5,
page
Go to
Step 7.
Replace the
2000-Sheet
Feeder
Board
[RRP 12.8,
page
Replace the
Print Engine
Controller
Board
[RRP 8.5,
page
Phaser 5400 Laser Printer Service Guide
No
Add paper to
the tray and
close.
Replace the
No Paper
Sensor
Actuator
[RRP 12.19,
page 371].
Go to Step 4
310].
Go to
Step 5.
Go to
Step 6.
360].
Go to
Step 8.
310].