Continuous Scan; Proof Copy - Kyocera KM-2540 Advanced Operation Manual

Place originals then press Start key.

Continuous Scan

Off
On
Ready to Proof Copy.

Proof Copy

Off
On
Check proof copy.
To stop and retry, press Cancel key.
To continue to print, press Start key.
Orig. Page
11×8½"
1 sided APS Monochrome, 1 side
Top Edge Collate
Job
1-24
Continuous Scan
Scans multiple originals for a single copy job without using the optional
document processor. Divide the original into smaller sets and scan each
set with the document processor. In Continuous Scan mode, you can
continue scanning originals until you press [Scanning finished].
Follow the steps as below to use continuous scan.
1
2
3
4
Shortcut Ba
Copy images from Do
platen for output as on
Proof Copy
Make a test copy of a single set to verify settings before printing the
remaining sets. If a problem is found, avoid wasting paper canceling the
remaining copy job.
Follow the steps below to do a Proof copy job.
1
2
3
4
Shortcut Ba
Proof copy outputs on
5
Count/Set Outpu
11×8½" Plain
Top
Change
Preset
Press [Function].
Press [Continuous Scan].
Press [On].
Place the original and press the Start key.
Place the next original and press the Start key. Scan the remaining
original pages in the same manner.
When done, press [Scanning finished]. Copying begins.
Press [Function] and then press [
Press [Proof Copy].
Press [On].
Place the original and press the Start key. The proof copy begins.
After printing a single test copy, a confirmation screen will be
displayed, and the copier will remain in standby mode until the job is
approved or cancelled. Check the proof copy.
If it is acceptable, press the Start key. The remaining sets will be
printed.
To change the copy quantity, press [Change Preset] and change the
copy count.
If there is a problem with the copy, press [Cancel] to redo the copy
settings.
Down].
Copy Functions