Kyocera KM-2540 Advanced Operation Manual page 48

1-38
Original Type
Select the original type according to type of original being scanned. The
following original types are available.
Original Type
1 sided (1-sided)
2 sided (2-sided)
Book
1
Press [Basic]. On the next screen, press [Original Type].
2
Select [1 sided] ([1-sided]), [2 sided] ([2-sided]) or [Book].
When selecting [2 sided], check the binding direction and be sure
that the originals are placed in the correct orientation.
When selecting [Book], be sure that the binding direction is correct.
Note [2 sided] ([2-sided]) is displayed when the optional
document processor is installed.
3
Press [Close].
1 sided/2 sided Copying
Select either [1 sided Copy] ([1-sided Copy]) or [2 sided Copy] ([2-sided
Copy]) for the finish type.
1
Press [Basic]. On the next screen, press [1 sided/2 sided] ([1-
sided/2-sided]).
Note 1 sided/2 sided copy selection is common to all steps. It
may only be configured as the first step.
2
Press [1 sided Copy] ([1-sided Copy]) or [2 sided Copy] ([2-sided
Copy]) and from Finishing select the binding direction.
3
Check the orientation of the original.
Note Incorrect copying may occur if the original is not placed
correctly.
4
Press [Close].
Finish
Set the Finish options. The following settings are available.
Offset (Group) – Each completed set is rotated 90 degrees to the next
before stacking.
Stapling – Use the optional document finisher or built-in finisher to
staple the completed copies.
1
Press [Basic]. On the next screen, press [Finished].
Note Finish settings are common for all steps. It may only be
configured as the first step.
2
For finishing, press [On] ([1 set]). For further details, refer to Offset
Mode on page 1-7.
For stapling, press [Staple Mode] and complete the settings. For
further details, refer to Stapling on page 1-8.
Description
Single sided sheet original.
2-sided sheet original.
Magazine or book originals with facing
pages.
Copy Functions