Kyocera KM-2540 Advanced Operation Manual page 105

Symptom
Copies are not clear.
Copies are dirty.
Copies are fuzzy.
Copies are skewed.
Paper jams frequently
occur.
Copies from the optional
document processor
have black lines.
Copies are wrinkled.
Troubleshooting
Checkpoints
Did you choose appropriate image
quality for the original?
Is the paper damp?
Are the original cover or platen
dirty?
Is the machine in a high humidity
environment?
Is the paper damp?
Are the originals loaded correctly?
Is the paper loaded correctly?
Is the paper loaded correctly?
Is the paper of the supported type?
Is it in good condition?
Is the paper curled, folded, or
wrinkled?
Are any loose scraps of paper or is
there any jammed paper inside the
device?
Is the paper damp?
Is the slit glass dirty?
—
Is the separator dirty?
Is the paper damp?
Is the paper set in a proper
orientation?
Corrective Actions
Select an appropriate original
image mode.
Replace the paper with new paper.
Clean the original cover or platen
glass.
Perform a drum refresh.
Replace the paper with new paper.
When placing originals on the
platen, place them face-down and
flush against the original size
indicator plates.
When placing originals in the
document processor, align the
original width guides securely
before placing the originals.
Check the position of the paper
width guides.
Load the paper correctly.
Remove the paper from the
cassette, turn it over, and reload it.
Replace the paper with new paper.
Remove any jammed paper.
Replace the paper with new paper.
Clean the slit glass.
Follow the procedure for correcting
black lines. This may remove the
black lines.
Clean the separator.
Replace the paper with new paper.
Change the orientation in which the
paper is positioned.
Reference Page
Refer to Operation
Guide, Chapter 3
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 5
page 3-25
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 6
Refer to Operation
Guide, Chapter 2
Refer to Operation
Guide, Chapter 5
page 3-4
Refer to Operation
Guide, Chapter 5
Refer to Operation
Guide, Chapter 2
—
5-3