Table of Contents
Advertisement
Chapter 5
IP Commands
bridge-group
To create and configure bridge groups, enter the bridge-group command in Global Configuration mode
or Ethernet Interface Configuration submode. To remove bridge groups or attributes of bridge groups,
use the no form of this command.
Syntax Description
bridgegroupID
broadcast-forwarding
eth-next-hop
ip-address
ib-next-hop
loop-protection
one
two
multicast
name
name-string
subnet-prefix
prefix
length
fail-over-priority
priority
redundancy-group
group
pkey
partition-key
dest
dest-addr
dest-mask
Defaults
This command has no default settings.
OL-9163-02
bridge-group bridgegroupID {broadcast-forwarding | eth-next-hop ip-address [dest
dest-addr dest-mask] | ib-next-hop ip-address [dest dest-addr dest-mask] | name
"name-string"| subnet-prefix prefix length | loop-protection {one | two} | multicast |
fail-over-priority priority | redundancy-group group}
bridge-group bridgegroupID [pkey partition-key]
no bridge-group bridgegroupID [broadcast-forwarding | eth-next-hop | ib-next-hop |
loop-protection {one | two} | multicast | redundancy-group group]
no bridge-group bridgegroupID [pkey | subnet-prefix prefix length]
Bridge group to create or reconfigure.
(Optional) Enables broadcast forwarding for the bridge group.
(Optional) Identifies the next-hop IP address connected to the ethernet
gateway.
(Optional) Next-hop IP address
(Optional) Identifies the next-hop IP address connected to the IB switch.
(Optional) Specifies the type of loop protection for the bridge-group.
Specifies type one loop protection (ARP packet painting enabled).
Specifies type two loop protection (ARP packet painting disabled).
(Optional) Enables IP-V4 multicast forwarding for the bridge group.
Assigns an ASCII text string identifier to the bridge group.
ASCII text string identifier for the bridge group.
(Optional) Assigns a subnet to the bridge-group.
(Optional) Subnet to assign to the bridge group.
(Optional) Length, in bits, of the subnet mask to assign to the bridge group.
Specifies the failover priority of the bridge group.
Integer value (1 - 255), where the lower the integer the higher the priority.
(Optional) Assigns the bridge group to a redundancy group.
(Optional) Redundancy group to which you want the bridge group to belong.
(Optional) Specifies a partition key to assign to the bridge group.
Partition key to assign to the bridge group.
(Optional) Specifies the destination subnet.
(Optional) Address of the destination subnet.
(Optional) Mask of the destination subnet.
Cisco SFS 7000 Series Product Family Command Reference Guide
bridge-group
5-3
Advertisement
Table of Contents
