Table of Contents
Advertisement
data-size
data-size
Configure the data size property of your test to customize the size of packets, frames, or IB packets that
your Server Switch uses for your test. To configure the payload size of an interface, enter the data-size
command in Interface Diagnostic Configuration submode. To clear the data size, use the no form of this
command.
Syntax Description
Data size defaults to 4 octets.
size
Command Modes
Interface Diagnostic Configuration submode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted and general read-write user.
Examples
The following example configures the payload size for a diagnostic test:
SFS-7000P(config-diag-if-fc-4/1)# data size 8
Related Commands
diagnostic
show interface ethernet
show interface fc
show interface gateway
start
stop
test
Cisco SFS 7000 Series Product Family Command Reference Guide
7-220
data-size size
no data-size size
Integer value that represents the payload size, in octets.
Chapter 7
Diagnostic Commands
OL-9163-02
Advertisement
Table of Contents
