Table of Contents
Advertisement
gateway
gateway
To assign a default IP gateway to
•
•
enter the gateway command in the appropriate Interface Configuration mode. To disassociate a port
from a gateway, use the no form of this command.
Syntax Description
gateway
Defaults
The gateway address defaults to 0.0.0.0.
Command Modes
Ethernet Management Interface Configuration (config-if-mgmt-ethernet) submode, InfiniBand
Management Interface Configuration (config-if-mgmt-ib) submode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted read-write user.
The gateway that you assign connects the port to the InfiniBand backplane on your Server Switch. You
must configure the gateway through the Serial Console port. Enter the IP address of the gateway when
you configure the management interfaces.
Examples
The following example assigns a default IP gateway to the Ethernet Management interface:
SFS-7000P(config-if-mgmt-ethernet)# gateway 10.3.0.94
The following example assigns a default IP gateway to the InfiniBand Management interface:
SFS-7000P(config-if-mgmt-ib)# gateway 10.3.0.2
Related Commands
show interface mgmt-ethernet
show interface mgmt-ib
snmp-server
Cisco SFS 7000 Series Product Family Command Reference Guide
2-38
the Ethernet Management port,
the virtual in-band InfiniBand port,
gateway gateway
no gateway
IP address of the gateway to assign to the port.
Chapter 2
Administrative Commands
OL-9163-02
Advertisement
Table of Contents
