Table of Contents
Advertisement
Chapter 6
Show Commands
show sensor
To display the temperature at several key locations in your Server Switch, enter the show sensor
command in User Exec mode or Privileged Exec mode.
Syntax Description
This command has no arguments or keywords.
Defaults
This command has no default settings.
Command Modes
User Execute mode, Privileged Execute mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
General read-only user.
The show sensor command identifies the temperature sensors in the system chassis. It also reports their
location in the chassis and the current temperature at that location. Chassis temperature should be
monitored to verify the cooling efficiency of the blowers and your data center air-conditioning.
Temperatures are in degrees Celsius and vary depending upon their location.
Normal temperature levels for the Cisco SFS 3001 remain 10 to 20 degrees Celsius above the ambient
temperature.
75 C would be an alarm temperature and the system will reset itself at 85 C.
Command Output:
Table 6-60
Table 6-80
Field
sensor
oper-status
oper-code (select Server Switches)
temperature
alarm-temp (select Server Switches)
shutdown-temp (select Server Switches) Temperature at which the sensor shuts down the Server
OL-9163-02
show sensor
describes the output of the show sensor command.
show sensor Command Field Descriptions
Descriptions
Number of the temperature sensor.
Operational status of the sensor ("up" or "down").
Operational code of the sensor.
Temperature that the sensor reads, in degrees Celsius.
Temperature at which the sensor sounds an alarm.
Switch.
Cisco SFS 7000 Series Product Family Command Reference Guide
show sensor
6-199
Advertisement
Table of Contents
