Table of Contents
Advertisement
Chapter 6
Show Commands
Table 6-72
Field
capability-mask
diag-code
mkey-lease-period
local-port-num
link-width-enabled
link-width-supported
link-width-active
link-speed-supported
OL-9163-02
sma port-info details Keyword Output Field Descriptions (continued)
Description
32-bit bitmask that specifies the supported capabilities of the port. A bit
value of 1 (one) indicates a supported capability. The bits are 0, 11-15, 18,
21-31 (Reserved and always 0.), 1 IsSM, 2 IsNoticeSupported, 3
IsTrapSupported, 4 IsResetSupported, 5 IsAutomaticMigrationSupported,
6 IsSLMappingSupported, 7 IsMKeyNVRAM (supports M_Key in
NVRAM), 8 IsPKeyNVRAM (supports P_Key in NVRAM), 9 Is LED
Info Supported, 10 IsSMdisabled, 16
IsConnectionManagementSupported, 17 IsSNMPTunnelingSupported, 19
IsDeviceManagementSupported, 20 IsVendorClassSupported.Values are
expressed in hexadecimal.
16-bit diagnostic code. For more information, see InfiniBand
Architecture®, Vol. 1, Release 1.1, section 14.2.5.6.1, "Interpretation of
Diagcode."
Initial value of the lease-period timer in seconds. The lease period is the
length of time that the M_Key protection bits are to remain non-zero after
a SubnSet (PortInfo) fails an M_Key check. After the lease period expires,
clearing the M_Key protection bits allows any subnet manager to read
(and then set) the M_Key. Set this field to 0 to indicate that the lease
period is never to expire. See InfiniBand Architecture®, Vol. 1, Release
1.1, section 14.2.4, "Management Key."
Number of the link port that received this request; otherwise, the value is
0.
Enabled link width (speed). The value is an integer that indicates the
enabled link-width sets for this port. The value may be
0 (no state change)
•
•
1 (1x)
2 (4x)
•
•
3 (1x or 4x)
8 (12x)
•
•
9 (1x or 12x)
10 (4x or 12x)
•
•
11 (1x, 4x or 12x)
255 (set this parameter to the link-width-supported value)
•
Supported link width. The value is 1 (1x), 3 (1x or 4x), or 11 (1x, 4x, or
12x).
Active link width. This parameter is used with LinkSpeedActive to
determine the link rate between the two connected nodes. The value is
width1x, width4x, or width12x.
Speed that the link between the host and your device supports.
Cisco SFS 7000 Series Product Family Command Reference Guide
show interface ib
6-171
Advertisement
Table of Contents
