Table of Contents
Advertisement
radius-server
radius-server
To configure up to three RADIUS servers that your Server Switch uses to authenticate CLI user logins,
enter the radius-server command in Global Configuration mode. To remove a RADIUS server from
the configuration, use the no form of this command.
Syntax Description
host
ip-address
auth-port
udp-port
timeout
seconds
retransmit
retries
key
encryption-key
Defaults
The RADIUS server IP address defaults to 0.0.0.0, which assigns no server, and the Server Switch
authenticates locally by default.
The udp-port variable defaults to 1812.
Command Modes
Global Configuration (config) mode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Unrestricted read-write access.
Cisco SFS 7000 Series Product Family Command Reference Guide
2-58
radius-server host ip-address [auth-port udp-port] [timeout seconds] [retransmit retries] [key
encryption-key]
no radius-server host ip-address
Specifies the IP address of the RADIUS server.
IP address of the RADIUS server.
(Optional) Specifies the user datagram protocol (UDP) authentication port
of the RADIUS server.
(Optional) UDP authentication port of the RADIUS server.
(Optional) Specifies the amount of time that your Server Switch waits for a
reply from the server before the login request times out.
(Optional) Amount of time, in seconds, that your Server Switch waits for a
reply from the server before the login request times out.
(Optional) Specifies the number of times that your Server Switch tries to
authenticate after a timeout.
(Optional) Number of times that your Server Switch tries to authenticate
after a timeout.
(Optional) Specifies the authentication key that the client and radius server
use.
(Optional) Encryption key that the client and radius server use.
Chapter 2
Administrative Commands
OL-9163-02
Advertisement
Table of Contents
