Table of Contents
Advertisement
Chapter 7
Diagnostic Commands
target-wwpn
To configure an optional WWPN identifier for a Fibre Channel interface Echo test, enter the
target-wwpn command in Fibre Channel Interface Diagnostic Configuration submode.
wwpn
Syntax Descriptionn
Defaults
This command has no default settings.
Command Modes
Configuration Diag Interface Fibre Channel (config-diag-if-fc) submode.
Usage Guidelines
Platform Availability:
Cisco SFS 3001, Cisco SFS 7000, Cisco SFS 7008, Cisco SFS 3012, Cisco 4x InfiniBand Switch Module
for IBM BladeCenter
Privilege Level:
Fibre Channelread-write user.
Examples
The following example enables database synchronization on the IB fabric:
SFS-7000P(config-diag-if-fc-4/1)# ib sm db-sync subnet-prefix fe:80:00:00:00:00:00:00
enable
Related Commands
diagnostic
show interface ethernet
show interface fc
show interface gateway
start
stop
test
OL-9163-02
source-wwpn wwpn
no source-wwpn wwpn
Optional 24-bit source identifier to use with the Fibre Channel interface
Echo test.
Cisco SFS 7000 Series Product Family Command Reference Guide
target-wwpn
7-225
Advertisement
Table of Contents
Need help?
Do you have a question about the SFS7000P-SK9 - SFS InfiniBand Server Switch 7000 and is the answer not in the manual?
Questions and answers