Table of Contents
Advertisement
speed
InfiniBand:
The speed command sets the administrative speed only. Self-detection determines the actual speed,
which depends on the capabilities of the connection. You must disable the auto-negotiation feature to
manually configure speed.
Examples
The following example sets the preferred speed to 1,000 Mbps (1 Gbps). The results of this command
may be viewed in the admin-speed field for Fibre Channel interfaces using the show interface fc
command:
SFS-7000P(config-if-fc-5/4)# speed 1000
The following example sets the ethernet interface (slot 4, port 1) to a speed of 100 Mbps:
SFS-7000P(config-if-ether-4/1)# speed 100
The following example sets all InfiniBand interfaces on a Cisco SFS 7000 to a speed of 4x:
SFS-120(config-if-ib-1/1-1/24)# speed 4x
Related Commands
auto-negotiate
half-duplex
show fc srp initiator
show interface ethernet
Cisco SFS 7000 Series Product Family Command Reference Guide
2-70
Chapter 2
Administrative Commands
OL-9163-02
Advertisement
Table of Contents
