Creating A Bridge Group - Cisco WS-C3550-12G Software Configuration Manual

Configuring Fallback Bridging

Creating a Bridge Group

To configure fallback bridging for a set of SVIs or routed ports, these interfaces must be assigned to
bridge groups. All interfaces in the same group belong to the same bridge domain. Each SVI or routed
port can be assigned to only one bridge group. A maximum of 31 bridge groups can be configured on
the switch.
Note The protected port feature is not compatible with fallback bridging. When fallback bridging is
enabled, it is possible for packets to be forwarded from one protected port on a switch to another
protected port on the same switch if the ports are in different VLANs.
Beginning in privileged EXEC mode, follow these steps to create a bridge group and assign an interface
to it:
Command
Step 1
configure terminal
Step 2 bridge bridge-group protocol
vlan-bridge
Step 3 interface interface-id
Step 4 bridge-group bridge-group
Step 5 end
Step 6
show running-config
Step 7
copy running-config startup-config
To remove a bridge group, use the no bridge bridge-group protocol vlan-bridge global configuration
command. To remove an interface from a bridge group, use the no bridge-group bridge-group interface
configuration command.
Catalyst 3550 Multilayer Switch Software Configuration Guide
26-4
Purpose
Enter global configuration mode.
Assign a bridge group number, and specify the VLAN-bridge
spanning-tree protocol to run in the bridge group. The ibm and dec
keywords are not supported.
For bridge-group, specify the bridge group number. The range is 1
to 255. You can create up to 31 bridge groups.
Frames are bridged only among interfaces in the same group.
Enter interface configuration mode, and specify the interface on which
you want to assign the bridge group.
The specified interface must be one of these:
A routed port: a physical port that you have configured as a Layer 3
•
port by entering the no switchport interface configuration
command.
An SVI: a VLAN interface that you created by using the interface
•
vlan vlan-id global configuration command.
These ports must have IP addresses assigned to them. For more
information, see the "Configuring Layer 3 Interfaces" section on
page 8-22.
Assign the interface to the bridge group created in Step 2.
By default, the interface is not assigned to any bridge group. An
interface can be assigned to only one bridge group.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 26 Configuring Fallback Bridging
78-11194-03