Xerox 850DP - Phaser Color Solid Ink Printer Manual page 98

Version 10.0
AccXES PJL Interface
Where undersize and oversize represent the percentage values in the undersize margin and oversize
margin parameters, respectively. MediaSizeDim and imageDim represent a corresponding dimension of
the candidate media size and the image size, respectively.
5.1.7.2.34 PAGECOMPPOSX
This parameter is active only when PAGECOMPENABLE is set ON. It specifies the location of the left
hand side (the X coordinate) of a constituent page after the rotation specified in PAGECOMPROTATE
has been applied. This location is specified in inches from the left side of the page composition canvas.
See the definition for PAGECOMPENABLE for details. The range of this variable is 0 to 1200 inches.
The default value is 0 inches.
5.1.7.2.35 PAGECOMPPOSY
This parameter is active only when PAGECOMPENABLE is set ON. It specifies the location of the
bottom hand side (the Y coordinate) of a constituent page after the rotation specified in
PAGECOMPROTATE has been applied. This location is specified in inches from the bottom side of the
page composition canvas. See the definition for PAGECOMPENABLE for details. The range of this
variable is 0 to 1200 inches. The default value is 0 inches.
5.1.7.2.36 PAGECOMPROTATE
This parameter is active only when PAGECOMPENABLE is set ON. It specifies the rotation of the
associated constituent page. A zero degree value means that the long edge of the constituent page is
aligned with the long edge of the canvas. The range of this variable is {0, 90, 180, 270} and the default
value is 0.
5.1.7.2.37 PAGEROTATE
The pages described within the user job may be rotated automatically or rotated by a specific amount
by the printer before printing. If autorotation is selected, the image is rotated automatically to fit the
specified paper's printable area. A paper's printable area is specified with the MARGINxx variables. If
the paper specified is a roll (specifying width only), then the image is rotated to print the least amount
of paper possible. In other words, the image is rotated to print with the long edge perpendicular to the
feed direction if the image won't be clipped to print the shortest amount of paper from the roll. If the
paper is specified to be a specific standard paper size, the long edge of the image is rotated to align with
the long edge of the specified paper size. The rotation parameter PAGEROTATE will contain one of {0,
90, 180, 270, or AUTO}. The factory default value for this parameter is 0 degrees.
The figures below denote the coordinate systems on roll paper sizes and standard cut sheet paper sizes
for a rotation angle of 0 degrees. Rotation is specified in the counter-clockwise direction. In words, 0
degrees rotation is when the X axis is aligned with the long edge of the standard paper size or in the
feed direction of a roll size. Note that when a standard paper size is specified which is printed long edge
first, the image is rotated 270 degrees to preserve the alignment of the X axis with the long edge of the
page. Therefore, whether a page is printed short edge or long edge first, the image placement on the
paper will be identical.
Page 93 of 160