Xerox 850DP - Phaser Color Solid Ink Printer Manual page 84

• Language
• Port Timeout
• Toner Density
• Maximum Plot Length
• Banner and Diagnostic page parameters
• Calcomp Emulation parameters (palette info, termination options, ...)
• HPGL Emulation parameters (palette info, termination options, ...)
• CGM Emulation parameters
• Versatec Raster Emulation parameters
• Versatec Data Standard Emulation parameters
• TIFF parameter
• Processing Defaults
• Collation and copy parameters
• Data format
• Job priority
• Finisher and other page composition parameters (justification, media source, ...)
• Label parameters
This information is taken from the associated (preceding) printed file's set of processing parameter
values.
5.1.7.1.11 MAXPLOTLEN
This parameter sets a maximum length that the printer will be allowed to print. When a plot that
exceeds this length is received and processed, the printer will truncate (clip) the plot to the length
specified in this parameter. The units of this parameter are inches. The value of this parameter may
range from 48" (4 feet) to 960" (86 feet). The default value is 960" (80 feet).
5.1.7.1.12 MM_MODE_PAPER
This parameter sets the policy for the printer in handling media mismatches for pages printed on a
paper media type. A media mismatch typically occurs when the job requires a paper size or roll size
which is not available in the printer at the time of printing. This parameter can take on one of three
values: BLOCK, SCALE, or SUBSTITUTE.
When the parameter is set to BLOCK, then the printer will halt operation just prior to printing the
mismatching page. The front panel of the printer will usually query the user to install the correct
media or cancel the job. Processing and printing of jobs behind the offending page is typically blocked
until the mismatch condition is resolved.
Version 10.0
AccXES PJL Interface
Page 79 of 160