Xesaccounting; Command Syntax (Pre 6.2); Returned Status (Pre 6.2) - Xerox 850DP - Phaser Color Solid Ink Printer Manual

6.9 XESACCOUNTING

This category is a custom AccXES extension to report job accounting information.

6.9.1 Command Syntax (pre 6.2)

The syntax for the XESACCOUNTING command is:
@PJL INFO XESACCOUNTING [ACCTNUM=<account #> SUBACCTNUM=<subaccount #>]
[UNITS=<units>]
The optional fields ACCTNUM and SUBACCTNUM specify an account to be reported.
If the specified SUBACCTNUM is zero, then the report will contain the accounting information on all
the subaccounts for the parent account specified in ACCTNUM. This request must be accompanied by a
valid password.
If the optional ACCTNUM and SUBACCTNUM fields are not present in the command, then the report
will contain the accounting information on all the accounts in the system. This request must be
accompanied by a valid password.
The optional UNITS field may be specified as either 'FT' or 'DM' for report values in square feet or
decimeters respectively.

6.9.2 Returned Status (pre 6.2)

After parsing the XESACCOUNTING command, the controller will echo the command, a listing of the
accounts and media values, and a form-feed back on the sending channel as shown below:
@PJL INFO XESACCOUNTING ACCTNUM=<account #> SUBACCTNUM=<subaccount #>
UNITS=<units>
ACCOUNT# SUB-ACCOUNT#
<acct #> <subacct #>
<FF>
If the command generates an error, the controller will echo the command, the appropriate status, and a
form-feed as shown below:
@PJL INFO XESACCOUNTING ACCTNUM=<account #> SUBACCTNUM=<subaccount #>
STATUS=<status>
<FF>
Possible status values are:
• STATUS = No Hard Disk - Accounting Disabled
• STATUS = invalid Password
• STATUS = invalid ACTION
• STATUS = invalid Account/SubAccount Num.
Version 10.0
AccXES PJL Interface
BOND VELLUM
<area #> <area #>
Page 109 of 160
FILM SCAN
<area #> <area #>