Xerox 850DP - Phaser Color Solid Ink Printer Manual page 94

Figure: Margins and Justification
5.1.7.2.16 VECMINLINEWIDTH
This job parameter controlls the minimum width (in pixels) for vector lines. The valid range is from 1
to 10 and the default value is 1.
5.1.7.2.17 TITLEBLOCK
For systems that have a GFI finisher attached, this parameter specifies where the title block is located
for the current page. This allows AccXES and/or the finisher to rotate the page as necessary to place
the title block in a visible location on the finished output.
5.1.7.2.18 FOLDER_GERA
Gera folder finisher options are encoded in this parameter. This is the folder currently selected for the
Rhino 8830 printer. If no finisher options are specified, the printer leaves this field in a Folder Bypass
state. The set of options available are {FOLD_BYPASS, FOLD_190, FOLD_210, FOLD_190_MARGIN,
FOLD_ANSI_A, FOLD_ARCH_A, FOLD_7HALFX11, FOLD_7HALFX11_MARGIN,
FOLD_GFIPROGRAM }.
Note that there are currently defined three Gera folder models. The Configuration Group parameter
FINISHERTYPE can denote which folder, if any, is currently attached. The table below shows which
folding options above can be used with which folder model.
Table: Gera Folder Configurations vs. Folding Options
Folding Option
FOLD_BYPASS
Version 10.0
AccXES PJL Interface
Supporting Folder Model
All Folders
Page 89 of 160