Emulation Group - Xerox 850DP - Phaser Color Solid Ink Printer Manual

Controller software version 10.0
Hide thumbs Also See for 850DP - Phaser Color Solid Ink Printer:
Table of Contents

Advertisement

When this parameter is enabled, then the print jobs pen settings will override the pen settings stored in
the printer's internal pen palette table. When disabled, then all pen settings including pen width, color,
and pattern index will be taken from the printer's internal pen palette and the job's requests to change
pen parameters will be ignored. The default value of this parameter is ON (enabled).
5.1.6.1.5 PASSWORD
This variable sets the printer's password to a value that ranges from 0 to 65535. When the password is
0, then no password checking is enforced in the printer for any operation. When it is non-zero, then a
password is required (placed in the JOB command) when performing operations such as DEFAULT and
several of the Xerox custom commands. The default value of this parameter is 0.
5.1.6.1.6 PMTREFRESH
This variable sets the refresh timeout for the WebPMT Main Page to a value that ranges from 5 to
3600. This value is measured in seconds. The WebPMT Main Page will refresh after the set number of
seconds as long as the user remains on the Main Page. This value will not reset with factory defaults.
The default value of this parameter is 10.
5.1.6.1.7 NESTINGMODE
This parameter specifies if plot nesting is enabled.
5.1.6.1.8 NESTINGTIMEOUT
This parameter specifies the plot nesting time-out value.
5.1.6.1.9 TIMEOUT
This parameter specifies the host communications port time-out period.
5.1.6.1.10 MM_QUEUING
This parameter specifies if mismatch queuing is enabled.
5.1.6.1.11 DATEFORMAT
This parameter specifies the current Date Format for dates displayed in the user interfaces, on Banner
pages, on Error/Warning pages, on Diagnostic pages, and within Label strings. Changing this value
will affect the date displayed on the printer front panel, on Web PMT pages, and on the indicated pages
and strings. The factory default value is IMPERIAL.
The following Date Formats are supported:
• IMPERIAL – date displayed as MM/DD/YYYY
• INTERNATIONAL – date displayed as DD/MM/YYYY

5.1.6.2 Emulation Group

This group of variables control the behavior of the data format interpreters. When using the SET or
DEFAULT command to set these parameters, the LPARM:<data format> qualifier may be used, as
described in the definition for SET and DEFAULT in [HP96]. However, it is NOT required. The
possible values of the LPARM qualifier are exactly those available for the PERSONALITY command.
Version 10.0
AccXES PJL Interface
Page 70 of 160

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 850DP - Phaser Color Solid Ink Printer and is the answer not in the manual?

Table of Contents