Xerox 850DP - Phaser Color Solid Ink Printer Manual page 39

Ethernet TCP/IP Port
Enable
Ethernet TCP/IP Gateway
Ethernet TCP/IP Netmask
Ethernet TCP/IP
RARP/BOOTP Enable
Group: TokenRing
TCPIP Port
Token Ring TCP/IP
Address
Version 10.0
AccXES PJL Interface
ETHERTCPIPENABLE
ETHERTCPIPGATEWAY
ETHERTCPIPNETMASK
ETHERTCPRARPENABL
E
TOKENTCPIPADDR
Page 34 of 160
R/W, Enum Enables or disables the
Ethernet TCP/IP protocol
on either the Digi MiLAN
3003 XTP NIC or the native
AccXES Ethernet
controller. When set to
PRINTER, the Digi MiLAN
3003XTP card will
implement the TCP/IP
protocol and related
services. When set to
ADVANCED, the native
AccXES TCP/IP
implementation will be
enabled. OFF disables all
TCP/IP services. Range:
{OFF, PRINTER_ONLY,
R/W, String All SNMP traps sent to
non-local hosts to be sent
through this gateway.
IPDefaultNetmask is used
to determine if a host is
local. The format for this
variable follows the
standard IP address
description. Range: String
of the form
nnn.nnn.nnn.nnn. Default:
R/W, String Setting this value to an IP
address causes the mask to
be used in determining
whether or not a host's
address is local to the NIC's
network segment. If not,
then the default gateway is
used. The mask is "anded"
with the address to
determine the network. The
format of the address
follows the standard IP
address description. Range:
String of the form
nnn.nnn.nnn.nnn. Default:
"255.255.252.0"
R/W, Bool Enables dynamic IP
address assignment with
the RARP and/or BOOTP
protocols. Range {ON, OFF}
Default: OFF
R/W, String Sets the IP address of the
printer on the network.
Range: String of the form
nnn.nnn.nnn.nnn. Default:
"13.240.20.38"