Xerox 850DP - Phaser Color Solid Ink Printer Manual page 85

Version 10.0
AccXES PJL Interface
When this parameter takes on the SCALE value, the mismatching job will first attempt to find the
smallest paper size which is larger than the required paper size (or roll size if the original requirement
was for a roll). To facilitate this search, autorotation is automatically set for the job when the job is
requesting a specific standard sheet size. This overrides the job's original setting for rotation. If a larger
size is found which accommodates the image justified on the page with the desired margins, the image
prints on this larger size as if it were the originally required size. Specifically, the originally requested
paper size's clip window is used when printing on the larger paper. Currently, the smaller requested
size is placed in the (0, 0) coordinate in physical space of the larger size selected (closest to the printer
operator control panel). If no larger size is available, the printer then looks for the largest size of this
media type in the system. If one is found, the page's image is autoscaled down to fit this new paper size
and printed. If no size is found at this point, then this page is treated as a blocking request for the
originally requested paper size if the paper code is supported by the system (as if MM_MODE_PAPER
were set to BLOCK). If the paper code requested is not supported by the system, then a roll size which
is closest in size to the width of the job's requested paper size is selected and processed.
When this parameter takes on the SUBSTITUTE value, the mismatching job will first attempt to
ignore any media source specification. If the job is still a mismatch, it will attempt to scale the job (as if
MM_MODE_PAPER were set to SCALE). If the job is still a mismatch, it will substitute another media
type.
The default value of this parameter is SCALE.
5.1.7.1.13 MM_MODE_[media type]
This parameter sets the policy for the printer in handling media mismatches for pages printed on the
specified media type. See MM_MODE_PAPER for a detailed explanation of these parameters. The
default value of these parameters is SCALE.
5.1.7.1.14 NESTINGEXCLUSIVE
This parameter specifies if plot nesting exclusive is enabled.
5.1.7.1.15 OWNER
This is a very important value to set in print jobs submitted to the AccXES controller. It is used to
denote the client, host, or user sending the job. When the job is referred to after it has been submitted
by a subsequent HP-PJL job, the owner is sometimes used to determine the right of this second job to
modify the first. For example, an HP-PJL job which attempts to cancel a previously submitted job must
have either a @PJL SET OWNER="XXXX" in it that matches a similar line in the previously submitted
job or must include the printer's password in the @PJL JOB command wrapping the cancel command.
The default value is "*".
5.1.7.1.16 PAGECOMPENABLE
This parameter is used for page composition. When set to ON, all the files contained with a printer job
will be composed onto the same physical sheet of paper. Otherwise, the job is a normal job. The default
value is OFF. This variable must be set prior to any files sent within the job.
JOB/EOJ pairs can be used to group files for page composition. Whenever a JOB or EOJ is
encountered, the current page composition group is ended, and a new one is started with the next file.
PJL jobs may be nested, so several pages composed in this way may be printed in a single PJL job by
nesting them.
Page 80 of 160