Version 10.0
AccXES PJL Interface
This collection of variables encodes whether the roll is defined in the manual feed port of the printer,
and if so, whether it is present and contains media, present but running low on media, or present but
empty. The possible values are: {NONE, FULL, LOW, EMPTY}.
5.1.8.3 Configuration Group
This parameter group stores values that describe the configuration of the printer. There are variables
recording the presence of mass storage devices, communication options, memory configurations, etc. All
of the variables in this group are read only.
5.1.8.3.1 CDROMPRESENT
This variable is TRUE when there is a CD ROM drive attached and available to the printer controller.
5.1.8.3.2 ESSSWREV
This string variable will store the current software revision of the printer controller.
5.1.8.3.3 FDDPRESENT
This variable is TRUE when a floppy drive attached and available to the printer controller.
5.1.8.3.4 FINISHERTYPE
This variable stores the type of finishing device currently attached and available to the printer. The
value is NONE if there is not a finisher device.
5.1.8.3.5 HDDPRESENT
This variable is TRUE when a hard disk drive is attached and available to the printer controller.
5.1.8.3.6 IOTSWREV
This string variable will store the current software revision of the marking engine firmware (which is
distinct from the printer controller software).
5.1.8.3.7 MODEMPRESENT
This variable is TRUE when there is a telephone modem attached and available to the printer
controller.
5.1.8.3.8 NICHWADDR
This string variable will contain the Ethernet or Token ring hardware address of the network interface
card if one is present. The variable NICTYPE can be queried to determine the presence of a network
interface card.
5.1.8.3.9 NICSWREV
This string variable will store the current software revision of the network interface card if one is
present.
5.1.8.3.10 NICTYPE
This variable will indicate which, if any, network interface card is currently attached and available to
the printer controller.
Page 102 of 160