Removing A Pci Add-In Card; Figure 61. Installing An Add-In Card - Intel SR1530AH - Server System - 0 MB RAM User Manual

5. Remove the screw at the rear of the riser assembly. See letter "A" in
Save this screw. You will reinstall it later.
6. If a filler panel is installed over the opening at the rear of the riser assembly lift it
from the riser assembly. See letter "B" in the figure. Save the filler panel in case
you later need to remove the add-in card.
7. Insert the add-in card into the socket in the riser assembly. Push the add-in card into
place firmly until it seats in the riser card connector, but use caution so you do not
twist or bend the card. See letter "C" in the figure.
8. Re-install the screw you removed in step 5. See letter "A" in the figure.
9. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser Assembly" on page
10. Install the server system cover. For instructions, see
Cover".
11. Plug all peripheral devices and the AC power cable into the server.

Removing a PCI Add-in Card

1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Remove the PCI riser assembly. For instructions, see
Assembly" on page
®
Intel Server System SR1530AH / SR1530AHLX / SR1530HAHLX
A

Figure 61. Installing an Add-In Card

iii.
28.
60.
B
C
61.
"Installing the Server System
"Removing the Server
"Removing the PCI Riser
Figure 61.
AF000674
"Safety
65