Memory - Intel SR1530AH - Server System - 0 MB RAM User Manual

Memory

The Intel
DIMM sockets across two banks, bank 1 and bank 2. Bank 1 consists of DIMM sockets
1A and 1B. Bank 2 consists of DIMM sockets 2A and 2B.
A minimum of one 256-MB DIMM is required in DIMM socket 1A. This uses single-
channel interleave. However, for dual-channel interleave, providing optimum
performance, a minimum of two DIMMs should be installed in DIMM sockets 1A and
2A. To operate in dual-channel dynamic paging mode, the following conditions must be
met:
•
Populate two identical DIMMs in sockets DIMM1A and DIMM 1B.
•
Populate four identical DIMMs in each socket location.
Note: Installing only three DIMMs is not supported. Use DIMMs that are the same type and
speed. Use of identical DIMMs is preferred.
DIMMs must meet the following requirements:
•
Use only DIMMs with DDR2 DRAM technology.
•
Use only DDR2-533 and DDR2-667 stacked DIMM modules.
In determining your memory requirements, the need for memory sparing or memory
mirroring must be considered. For a complete list of supported memory DIMMs, see the
links under
®
Intel Server System SR1530AH / SR1530AHLX / SR1530HAHLX
®
Server System SR1530AH / SR1530AHLX / SR1530HAHLX provides four
"Server System References" on page x.
17