Removing the Rack Handles
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the front bezel if it is installed. For instructions, see
Bezel" on page
4. Remove the two screws holding the rack handle in place, and remove the rack
handle from the server system as shown in the figure below.
5. Repeat step 4 on the opposite side of the system.
6. Optional: Install the front bezel, if desired. For instructions, see
Front Bezel" on page
7. Plug all peripheral devices and the AC power cable into the server.
94
iii.
26.
Figure 87. Removing the Rack Handle
27.
®
Intel
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
"Removing the Front
AF001204
"Installing the
"Safety