Replacing A Cooling Fan (Sr1530Ah / Sr1530Ahlx); Replacing The System Blower Fans (Sr1530Ah / Sr1530Ahlx); Remove The Processor Air Duct. For Instructions, See - Intel SR1530AH - Server System - 0 MB RAM User Manual

Replacing a Cooling Fan (SR1530AH /
SR1530AHLX)
Caution: The fans are NOT hot swappable. Before removing or replacing a fan, you must first take
the server out of service, turn off all peripheral devices connected to the system, turn off
the system by pressing the power button, and unplug the AC power cord from the system
or wall outlet.
Note: The fans that are integrated into the power supply cannot be replaced separately. If one of
the fans in the power supply fails, the power supply must be replaced.
The blower fans can be individually replaced if one of them fails. If a fan in the power
supply fails, the power supply must be replaced. Use the steps below to replace a system
blower fan or the PCI cooling fan.
Replacing the System Blower Fans (SR1530AH /
SR1530AHLX)
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System

4. Remove the processor air duct. For instructions, see

Duct" on page 31
5. Disconnect the two fan cables from the server board. See letters "A" and "B" in the
figure below.
84
iii.
Cover".
®
Intel Server System SR1530AH / SR1530AHLX / SR1530HAHLX
"Removing the Server
"Removing the Processor Air
"Safety